203. NX 四层环境下，执行命令的方法

admin

( w1 B1 i3 \) [& H1 j

[mw_shl_code=bash,true]Start an NX command shell and set the following variables:

$ Q" O! E* b- m( O& s' D    set FMS_HOME=<path to TCcs>
- a/ D# v( ~6 Z" C# J9 n% D7 j    set UGII_UGMGR_COMMUNICATION=HTTP
    set UGII_UGMGR_HTTP_URL=http://<servername>:<port>/path
3 @, ]+ J' M8 u: N
7 S3 W' b; [  N7 X4 `If you are unsure of the URL run the Configuration Manager in TEM to perform
/ E4 \5 ~4 d" P9 i( T2 m4 p& dmaintenance on your existing 4-tier configuration.  Choose Modify 4-tier
server settings to list the URI of the server.        Enter this path for the
0 t% l5 n4 k  O' L! ~+ Zvariable.
1 P7 o# L6 W6 o- I% b+ g
: b' [8 n. w0 g$ ]  M5 vOptional: At this point you can verify that NX starts and is communicating
with TC by entering the following command: ugraf -pim=yes -u=<username>
* c3 l) e- G8 r-p=<password> -g=<group>.  Close the NX session.

4 I  N, ~1 T$ A$ h4 q9 w  E6 v) rTo execute the ugtopv command you can either set the PVTRANSUI_DIR as per the
ugii_env_ug.dat, or change your directory to the pvtrans directory prior to
" a' O; N! U/ mrunning the command.

1 ~, X" W' c9 ?* u- o+ s4 T9 h    set PVTRANSUI_DIR=%UGII_BASE_DIR%\pvtrans

Finally, enter the ugtopv command: ugtopv @DB/<item>/<rev> -pim=yes -u -p -g[/mw_shl_code]